mayhem-firmware/firmware/baseband/mcuconf.h

/*
    ChibiOS/RT - Copyright (C) 2006-2013 Giovanni Di Sirio
                 Copyright (C) 2014 Jared Boone, ShareBrained Technology

    Licensed under the Apache License, Version 2.0 (the "License");
    you may not use this file except in compliance with the License.
    You may obtain a copy of the License at

        http://www.apache.org/licenses/LICENSE-2.0

    Unless required by applicable law or agreed to in writing, software
    distributed under the License is distributed on an "AS IS" BASIS,
    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
    See the License for the specific language governing permissions and
    limitations under the License.
*/

/*
 * LPC43xx drivers configuration.
 * The following settings override the default settings present in
 * the various device driver implementation headers.
 * Note that the settings for each driver only have effect if the whole
 * driver is enabled in halconf.h.
 *
 * IRQ priorities:
 * 7...0       Lowest...Highest.
 */

/* NOTE: Beware setting IRQ priorities < "2":
 * dbg_check_enter_isr "#SV8 means that probably you have some IRQ set at a
 * priority level above the kernel level (level 0 or 1 usually) so it is able
 * to preempt the kernel and mess things up.
 */

/*
 * DMA driver system settings.
 */

//#define LPC_ADC0_IRQ_PRIORITY               2
#define LPC_DMA_IRQ_PRIORITY                3
//#define LPC_ADC1_IRQ_PRIORITY               4

#define LPC43XX_M0APPTXEVENT_IRQ_PRIORITY   4

/* M4 is initialized by M0, which has already started PLL1 */
#if !defined(LPC43XX_M4_CLK) || defined(__DOXYGEN__)
#define LPC43XX_M4_CLK                      200000000
#endif