ChibiOS 2.6.8, until I can figure out where to get it from git.

firmware/chibios/boards/NGX_BB_LPC11U14/board.c

@@ -0,0 +1,61 @@
+/*
+    ChibiOS/RT - Copyright (C) 2006-2013 Giovanni Di Sirio
+
+    Licensed under the Apache License, Version 2.0 (the "License");
+    you may not use this file except in compliance with the License.
+    You may obtain a copy of the License at
+
+        http://www.apache.org/licenses/LICENSE-2.0
+
+    Unless required by applicable law or agreed to in writing, software
+    distributed under the License is distributed on an "AS IS" BASIS,
+    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+    See the License for the specific language governing permissions and
+    limitations under the License.
+*/
+
+#include "ch.h"
+#include "hal.h"
+
+/**
+ * @brief   PAL setup.
+ * @details Digital I/O ports static configuration as defined in @p board.h.
+ *          This variable is used by the HAL when initializing the PAL driver.
+ */
+#if HAL_USE_PAL || defined(__DOXYGEN__)
+const PALConfig pal_default_config = {
+  {VAL_GPIO0DATA, VAL_GPIO0DIR},
+  {VAL_GPIO1DATA, VAL_GPIO1DIR}
+};
+#endif
+
+/*
+ * Early initialization code.
+ * This initialization must be performed just after stack setup and before
+ * any other initialization.
+ */
+__inline void __early_init(void) {
+
+  lpc_clock_init();
+}
+
+/*
+ * Board-specific initialization code.
+ */
+__inline void boardInit(void) {
+
+  /* LCD */
+  LPC_IOCON->TMS_PIO0_12  = 0x91;       /* LCD_EN: GPIO - pull-up     */
+  LPC_IOCON->TDO_PIO0_13  = 0x81;       /* LCD_RW: GPIO - No pull-up  */
+  LPC_IOCON->TRST_PIO0_14 = 0x81;       /* LCD_RS: GPIO - No pull-up  */
+
+  /* USART */
+  LPC_IOCON->PIO0_18 = 0x81;            /* RDX: RXD - No pull-up      */
+  LPC_IOCON->PIO0_19 = 0x81;            /* TDX: TXD - No pull-up      */
+
+  /* Test LEDs */
+  LPC_IOCON->PIO0_22 = 0x80;            /* LED_TEST1: GPIO - No pull-up */
+  LPC_IOCON->PIO0_23 = 0x80;            /* LED_TEST2: GPIO - No pull-up */
+
+}
+