ChibiOS 2.6.8, until I can figure out where to get it from git.

firmware/chibios/boards/OLIMEX_LPC-P1227/board.h

@@ -0,0 +1,94 @@
+/*
+    ChibiOS/RT - Copyright (C) 2006-2013 Giovanni Di Sirio
+
+    Licensed under the Apache License, Version 2.0 (the "License");
+    you may not use this file except in compliance with the License.
+    You may obtain a copy of the License at
+
+        http://www.apache.org/licenses/LICENSE-2.0
+
+    Unless required by applicable law or agreed to in writing, software
+    distributed under the License is distributed on an "AS IS" BASIS,
+    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+    See the License for the specific language governing permissions and
+    limitations under the License.
+*/
+
+#ifndef _BOARD_H_
+#define _BOARD_H_
+
+/*
+ * Setup for Olimex LPC-P1227 board.
+ *
+ */
+
+/*
+ * Board identifiers.
+ */
+#define OLIMEX_LPC_P1227
+#define BOARD_NAME "Olimex LPC-P1227"
+
+/*
+ * Board frequencies.
+ */
+#define SYSOSCCLK               12000000
+
+
+/*
+ * GPIO 0 initial setup.
+ */
+#define VAL_GPIO0DIR            0x00000000
+#define VAL_GPIO0DATA           0x00000000
+
+/*
+ * GPIO 1 initial setup.
+ */
+#define VAL_GPIO1DIR            PAL_PORT_BIT(GPIO1_LED1)   |                 \
+                                PAL_PORT_BIT(GPIO1_LED2)   |                 \
+                                PAL_PORT_BIT(GPIO1_BUZZER)
+
+#define VAL_GPIO1DATA           PAL_PORT_BIT(GPIO1_LED1)
+
+
+/*
+ * GPIO 2 initial setup.
+ */
+#define VAL_GPIO2DIR            PAL_PORT_BIT(GPIO2_LCD_DC)   |               \
+                                PAL_PORT_BIT(GPIO2_LCD_SS)   |               \
+                                PAL_PORT_BIT(GPIO2_LCD_RES)
+#define VAL_GPIO2DATA           PAL_PORT_BIT(GPIO2_LCD_SS)
+
+
+/*
+ * Pin definitions.
+ */
+
+#define GPIO1_LED1              5
+#define GPIO1_LED2              4
+#define GPIO1_SW_WAKEUP         3
+#define GPIO1_BUZZER            6
+
+#define GPIO2_SW_USER1          12
+#define GPIO2_SW_USER2          11
+#define GPIO2_SW_USER3          10
+#define GPIO2_LCD_DC            15
+#define GPIO2_LCD_SS            14
+#define GPIO2_LCD_RES           13
+
+/* LCD3310 pins */
+#define LCD3310_RES_PIN   GPIO2_LCD_RES
+#define LCD3310_RES_PORT  GPIO2
+#define LCD3310_DC_PIN    GPIO2_LCD_DC
+#define LCD3310_DC_PORT   GPIO2
+
+#if !defined(_FROM_ASM_)
+#ifdef __cplusplus
+extern "C" {
+#endif
+  void boardInit(void);
+#ifdef __cplusplus
+}
+#endif
+#endif /* _FROM_ASM_ */
+
+#endif /* _BOARD_H_ */