ChibiOS 2.6.8, until I can figure out where to get it from git.

firmware/chibios/demos/ARMCM0P-LPC812-LPCXPRESSO/mcuconf.h

@@ -0,0 +1,78 @@
+/*
+    ChibiOS/RT - Copyright (C) 2006-2013 Giovanni Di Sirio
+
+    Licensed under the Apache License, Version 2.0 (the "License");
+    you may not use this file except in compliance with the License.
+    You may obtain a copy of the License at
+
+        http://www.apache.org/licenses/LICENSE-2.0
+
+    Unless required by applicable law or agreed to in writing, software
+    distributed under the License is distributed on an "AS IS" BASIS,
+    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+    See the License for the specific language governing permissions and
+    limitations under the License.
+*/
+
+/*
+ * LPC812 drivers configuration.
+ * The following settings override the default settings present in
+ * the various device driver implementation headers.
+ * Note that the settings for each driver only have effect if the driver
+ * is enabled in halconf.h.
+ *
+ * IRQ priorities:
+ * 3...0        Lowest...highest.
+ */
+
+/*
+ * HAL driver system settings.
+ */
+
+/* Default: Run PLL @24MHz from 12MHz IRC
+  #define LPC8xx_PLLCLK_SOURCE               SYSPLLCLKSEL_IRCOSC
+  #define LPC8xx_SYSPLL_MUL                  4
+  #define LPC8xx_SYSPLL_DIV                  4
+  #define LPC8xx_MAINCLK_SOURCE              SYSMAINCLKSEL_PLLOUT
+  #define LPC8xx_SYSABHCLK_DIV               1
+*/
+
+/*run directly from internal 12M osc...*/
+#define LPC8xx_MAINCLK_SOURCE              SYSMAINCLKSEL_IRCOSC
+
+/*
+ * GPT driver system settings.
+ */
+/* Defaults:
+  #define LPC8xx_GPT_USE_MRT0              TRUE
+  #define LPC8xx_GPT_USE_MRT1              FALSE
+  #define LPC8xx_GPT_USE_MRT2              FALSE
+  #define LPC8xx_GPT_USE_MRT3              FALSE
+  #define LPC8xx_GPT_MRT_IRQ_PRIORITY      2
+*/
+
+/*
+ * PWM driver system settings.
+ */
+
+/*
+ * SERIAL driver system settings.
+ */
+/* Defaults:
+  #define LPC8xx_SERIAL_USE_UART0            TRUE
+  #define LPC8xx_SERIAL_USE_UART1            FALSE
+  #define LPC8xx_SERIAL_USE_UART2            FALSE
+  #define LPC8xx_SERIAL_UART0_IRQ_PRIORITY   3
+  #define LPC8xx_SERIAL_UART1_IRQ_PRIORITY   3
+  #define LPC8xx_SERIAL_UART2_IRQ_PRIORITY   3
+
+  #define LPC8xx_SERIAL_U_PCLK              11059200
+  #define LPC8xx_SERIAL_UARTCLKDIV          !!Calculated!!
+  #define LPC8xx_SERIAL_UARTFRGMUL          !!Calculated!!
+  #define LPC8xx_SERIAL_UARTFRGDIV          !!Calculated!!
+*/
+
+/* change default baudrate to 9600 */
+#define SERIAL_DEFAULT_BITRATE              9600
+
+