ChibiOS 2.6.8, until I can figure out where to get it from git.

firmware/chibios/demos/PPC-SPC564A-GCC/mcuconf.h

@@ -0,0 +1,66 @@
+/*
+    SPC5 HAL - Copyright (C) 2013 STMicroelectronics
+
+    Licensed under the Apache License, Version 2.0 (the "License");
+    you may not use this file except in compliance with the License.
+    You may obtain a copy of the License at
+
+        http://www.apache.org/licenses/LICENSE-2.0
+
+    Unless required by applicable law or agreed to in writing, software
+    distributed under the License is distributed on an "AS IS" BASIS,
+    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+    See the License for the specific language governing permissions and
+    limitations under the License.
+*/
+
+/*
+ * SPC563Mxx drivers configuration.
+ * The following settings override the default settings present in
+ * the various device driver implementation headers.
+ * Note that the settings for each driver only have effect if the whole
+ * driver is enabled in halconf.h.
+ *
+ * IRQ priorities:
+ * 1...15       Lowest...Highest.
+ */
+
+#define SPC564Axx_MCUCONF
+
+/*
+ * HAL driver system settings.
+ */
+#define SPC5_NO_INIT                        FALSE
+#define SPC5_CLK_BYPASS                     FALSE
+#define SPC5_ALLOW_OVERCLOCK                FALSE
+#define SPC5_CLK_PREDIV_VALUE               2
+#define SPC5_CLK_MFD_VALUE                  75
+#define SPC5_CLK_RFD                        SPC5_RFD_DIV2
+#define SPC5_FLASH_BIUCR                    (BIUCR_BANK1_TOO |              \
+                                             BIUCR_MASTER4_PREFETCH |       \
+                                             BIUCR_MASTER0_PREFETCH |       \
+                                             BIUCR_DPFEN |                  \
+                                             BIUCR_IPFEN |                  \
+                                             BIUCR_PFLIM_ON_MISS |          \
+                                             BIUCR_BFEN)
+
+/*
+ * ADC driver settings.
+ */
+#define SPC5_ADC_USE_ADC0_Q0                FALSE
+#define SPC5_ADC_USE_ADC0_Q1                FALSE
+#define SPC5_ADC_USE_ADC0_Q2                FALSE
+#define SPC5_ADC_USE_ADC1_Q3                FALSE
+#define SPC5_ADC_USE_ADC1_Q4                FALSE
+#define SPC5_ADC_USE_ADC1_Q5                FALSE
+#define SPC5_ADC_CR_CLK_PS                  ADC_CR_CLK_PS(5)
+
+/*
+ * SERIAL driver system settings.
+ */
+#define SPC5_USE_ESCIA                      TRUE
+#define SPC5_USE_ESCIB                      TRUE
+#define SPC5_USE_ESCIC                      TRUE
+#define SPC5_ESCIA_PRIORITY                 8
+#define SPC5_ESCIB_PRIORITY                 8
+#define SPC5_ESCIC_PRIORITY                 8