* Activating TX Low Pass Filter in Second IF IC
* solving PR conversation revisions
* Final TX LPF decision for ADSB_TX
* Small comments correction.
* Added set TX LPF also in APRS, BurgerPgr,Jammer
* Attempt to fix Capture startup hang
* Pump baseband_queue on M4 startup
* Synchronization experiment
* Moved SpectrumCapture member, better hang detection for M0
* Prevent execute from working on members until class has been initialized.
* Formatting
* Remove workaround.
* Rebase on next
* Set rf direction in RadioState
* centralize cpld load for TX->RX
* Remove calls to load_sram from all apps
* re-add CPLD hack, don't set radio values directly.
---------
Co-authored-by: kallanreed <kallanreed@noreply.github.com>
* Use receiver/transmitter models everywhere
* Run formatter
* Fix a copy-paste bug, make transmitter_model actually set tx_gain.
---------
Co-authored-by: kallanreed <kallanreed@outlook.com>
* Added HamItUp option to allow quick offset of the tuned frequency
* New HamItUp icon for top bar
* HamItUp checkbox status and frequency persistent settings in Settings/Radio
Addresses long-standing and annoying bug where SGPIO DMA channel would not disable -- and not configure cleanly next time it was needed. My theory is that the DMA channel couldn't disable until it got a request from the peripheral, and sometimes the peripheral was disabled before that last request.
Anyway, the baseband firmware should control the SGPIO, methinks, despite the impact on baseband code size.
Turns out 0x10088000 - 0x10089fff is not the right place. It's 0x40041000, and is only 256 bytes!
Move PPM to correct place, change representation to PPB for finer control.
Reset PPB value to initial value if read value out of bounds.
Clip PPB value on write to permitted bounds.
Contributes to resolution of issue #11.
