Sending shared contacts isn't backwards-compatible, so we want to have a
few releases where receiving is enabled, but not sending. That way, when
we enable sending, most users should be able to properly receive the
shared contact messages.
When you share a vCard from an external app (like the Contacts app) into
Signal, we'll now convert it to a pretty Shared Contact message and
allow you to choose which fields of the contact you wish to send.
The "contact" option in the attachments tray now brings you through an
optimized contact sharing flow, allowing you to select specific fields
to share. The contact is then presented as a special message type,
allowing you to interact with the card to add the contact to your system
contacts, invite them to signal, initiate a signal message, etc.
There's a chance that the AsyncTask that retrieves a quoted message's
position could finish after the fragment is detached, which would cause
a crash. I've changed it so if this case occurs, the result is ignored.
Also, I noticed that when searching the message table, if a quote can't
be found, we'd end up traversing the entire table. To prevent this from
taking forever on large message tables, I've limited it to searchin only
what is currently present in the adapter.
Fixes#7756
Did a refactor to better organize the camera flipping code. Also, I
wanted to make sure we handle the cases where the user doesn't have two
cameras (or no cameras, for that matter). In these cases, we just don't
show the appropriate buttons.
Previously, quotes were not saved to drafts, meaning they would be lost
when leaving the conversation or app. Now, a QuoteId (which represents
the necessary data to restore the QuoteModel) is serialized and stored
in the DraftDatabase.
Fixes#7716Closes#7729
Unfortunately, the change wasn't as simple as just switching to use our
EmojiTextView. That view only supported single-line text. I added
support for multi-line text.
Fixes#7704.
We now check if _any_ text is selected when doing a batch selection
to determine if we should show the copy option. Also, previously it
was putting in empty lines for messages that don't have any text. I
changed it so empty messages have no effect on the text that is copied.
Fixes#7472
