With a42a594bb3, iOS uses netstack and
hence there are no longer any platforms which use the legacy MagicDNS path. As such, we remove it.
We also normalize the limit for max in-flight DNS queries on iOS (it was 64, now its 256 as per other platforms).
It was 64 for the sake of being cautious about memory, but now we have 50Mb (iOS-15 and greater) instead of 15Mb
so we have the spare headroom.
Signed-off-by: Tom DNetto <tom@tailscale.com>
This is temporary while we work to upstream performance work in
https://github.com/WireGuard/wireguard-go/pull/64. A replace directive
is less ideal as it breaks dependent code without duplication of the
directive.
Signed-off-by: Jordan Whited <jordan@tailscale.com>
In the future this will cause a node to be unable to join the tailnet
if network logging is enabled.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
If the network logging configruation changes (and nothing else)
we will tear down the network logger and start it back up.
However, doing so will lose the router configuration state.
Manually reconfigure it with the routing state.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
There is utility in logging traffic statistics that occurs at the physical layer.
That is, in order to send packets virtually to a particular tailscale IP address,
what physical endpoints did we need to communicate with?
This functionality logs IP addresses identical to
what had always been logged in magicsock prior to #5823,
so there is no increase in PII being logged.
ExtractStatistics returns a mapping of connections to counts.
The source is always a Tailscale IP address (without port),
while the destination is some endpoint reachable on WAN or LAN.
As a special case, traffic routed through DERP will use 127.3.3.40
as the destination address with the port being the DERP region.
This entire feature is only enabled if data-plane audit logging
is enabled on the tailnet (by default it is disabled).
Example of type of information logged:
------------------------------------ Tx[P/s] Tx[B/s] Rx[P/s] Rx[B/s]
PhysicalTraffic: 25.80 3.39Ki 38.80 5.57Ki
100.1.2.3 -> 143.11.22.33:41641 15.40 2.00Ki 23.20 3.37Ki
100.4.5.6 -> 192.168.0.100:41641 10.20 1.38Ki 15.60 2.20Ki
100.7.8.9 -> 127.3.3.40:2 0.20 6.40 0.00 0.00
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
This sets up Logger to handle statistics at the magicsock layer,
where we can correlate traffic between a particular tailscale IP address
and any number of physical endpoints used to contact the node
that hosts that tailscale address.
We also export Message and TupleCounts to better document the JSON format
that is being sent to the logging infrastructure.
This commit does NOT yet enable the actual logging of magicsock statistics.
That will be a future commit.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
If the wgcfg.Config is specified with network logging arguments,
then Userspace.Reconfig starts up an asynchronous network logger,
which is shutdown either upon Userspace.Close or when Userspace.Reconfig
is called again without network logging or route arguments.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
Most visible when using tsnet.Server, but could have resulted in dropped
messages in a few other places too.
Fixes#5743
Signed-off-by: Mihai Parparita <mihai@tailscale.com>
Avoid contention from fetching status for all peers, and instead fetch
status for a single peer.
Updates tailscale/coral#72
Signed-off-by: James Tucker <james@tailscale.com>
Hashing []any is slow since hashing of interfaces is slow.
Hashing of interfaces is slow since we pessimistically assume
that cycles can occur through them and start cycle tracking.
Drop the variadic signature of Update and fix callers to pass in
an anonymous struct so that we are hashing concrete types
near the root of the value tree.
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
Signed-off-by: Joe Tsai <joetsai@digital-static.net>
We were marking them as gauges, but they are only ever incremented,
thus counter is more appropriate.
Signed-off-by: Mihai Parparita <mihai@tailscale.com>
This change wires netstack with a hook for traffic coming from the host
into the tun, allowing interception and handling of traffic to quad-100.
With this hook wired, magicDNS queries over UDP are now handled within
netstack. The existing logic in wgengine to handle magicDNS remains for now,
but its hook operates after the netstack hook so the netstack implementation
takes precedence. This is done in case we need to support platforms with
netstack longer than expected.
Signed-off-by: Tom DNetto <tom@tailscale.com>
A subsequent commit implements handling of magicDNS traffic via netstack.
Implementing this requires a hook for traffic originating from the host and
hitting the tun, so we make another hook to support this.
Signed-off-by: Tom DNetto <tom@tailscale.com>
* net/dns, net/dns/resolver, wgengine: refactor DNS request path
Previously, method calls into the DNS manager/resolver types handled DNS
requests rather than DNS packets. This is fine for UDP as one packet
corresponds to one request or response, however will not suit an
implementation that supports DNS over TCP.
To support PRs implementing this in the future, wgengine delegates
all handling/construction of packets to the magic DNS endpoint, to
the DNS types themselves. Handling IP packets at this level enables
future support for both UDP and TCP.
Signed-off-by: Tom DNetto <tom@tailscale.com>
When `setWgengineStatus` is invoked concurrently from multiple
goroutines, it is possible that the call invoked with a newer status is
processed before a call with an older status. e.g. a status that has
endpoints might be followed by a status without endpoints. This causes
unnecessary work in the engine and can result in packet loss.
This patch adds an `AsOf time.Time` field to the status to specifiy when the
status was calculated, which later allows `setWgengineStatus` to ignore
any status messages it receives that are older than the one it has
already processed.
Updates tailscale/corp#2579
Signed-off-by: Maisem Ali <maisem@tailscale.com>
A new package can also later record/report which knobs are checked and
set. It also makes the code cleaner & easier to grep for env knobs.
Change-Id: Id8a123ab7539f1fadbd27e0cbeac79c2e4f09751
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Fixes#3660
RELNOTE=MagicDNS now works over IPv6 when CGNAT IPv4 is disabled.
Change-Id: I001e983df5feeb65289abe5012dedd177b841b45
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Allow users of CallbackRouter to supply a GetBaseConfig
implementation. This is expected to be used on Android,
which currently lacks both a) platform support for
Split-DNS and b) a way to retrieve the current DNS
servers.
iOS/macOS also use the CallbackRouter but have platform
support for SplitDNS, so don't need getBaseConfig.
Updates https://github.com/tailscale/tailscale/issues/2116
Updates https://github.com/tailscale/tailscale/issues/988
Signed-off-by: Denton Gentry <dgentry@tailscale.com>
In prep for moving stuff out of LocalBackend.
Change-Id: I9725aa9c3ebc7275f8c40e040b326483c0340127
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
Not done yet, but this move more of the outbound dial special casing
from random packages into tsdial, which aspires to be the one unified
place for all outbound dialing shenanigans.
Then this plumbs it all around, so everybody is ultimately
holding on to the same dialer.
As of this commit, macOS/iOS using an exit node should be able to
reach to the exit node's DoH DNS proxy over peerapi, doing the sockopt
to stay within the Network Extension.
A number of steps remain, including but limited to:
* move a bunch more random dialing stuff
* make netstack-mode tailscaled be able to use exit node's DNS proxy,
teaching tsdial's resolver to use it when an exit node is in use.
Updates #1713
Change-Id: I1e8ee378f125421c2b816f47bc2c6d913ddcd2f5
Signed-off-by: Brad Fitzpatrick <bradfitz@tailscale.com>
wgengine/wgcfg: introduce wgcfg.NewDevice helper to disable roaming
at all call sites (one real plus several tests).
Fixestailscale/corp#3016.
Signed-off-by: David Anderson <danderson@tailscale.com>
Signed-off-by: Josh Bleecher Snyder <josh@tailscale.com>
